Damper

I’m having problems with damper nodes, its attached to the L of an HSL node of a quad, but when I switch it from 1 to 0, it just switches, if I open inspektor and attach it, it works fine. I have other dampers doing movements, and they’re working fine.
Bit odd?
Cat

Just worked out why its strange, I was also enabling the quad at the same time, but presumably its meant to work as I imagined not cut in?

the quad would be disabled as enabled is less than 0.5, right?

No the quad switches from 0 to 1, the same switch goes to a damper which fades in the quad, so the quad should switch on, and the fade should start at the same time.