hej,
playin around with the b-spline node, I set the controls per curve count higher than the count of controls which causes the node to give no output any more. not even when setting back controls per curve to -1.
maybe bug or just my fault?
woei
ok
it’s a bug.
merci
finally fixed
something else, thou i’m not quite sure, if it’s not my cpu…
on rapid change on the input of the b-spline node it hangs up after a while not outputing anything any more, not even things like 0 or Ø.
i hope this was the same bug i just fixed.
however i only can make the proof if you are able to post a patch which doesn’t work on your computer, so can test it.
seb
seems to be fixed. everything works fine here. beta9.1 is coming soon! grts, greg